Table 3-1. Unit Level Preventive Maintenance Checks and Services (PMCS) for IHMEE. -- Continued
Item to be
Not Fully Mission
· If performing the next higher service,
vehicle conditions must remain the same.
· If not performing the next higher service,
the following must be performed prior to
final road test:
· Operate engine for 5 min., and check
housing for leaks. Shut OFF engine, check
a. Jack vehicle and remove safety stands
d. Install engine access panel
e. Install hydraulic reservoir step plate
FINAL ROAD TEST
After all services and inspections have been
completed, take vehicle on short road test to
ensure all corrections have been
accomplished. Correct any defects or
malfunctions that occur during this test.
During road test:
Unusual noises present.
a. Listen for any unusual noises.
b. Check steering operation.
c. Check operation of brakes.
d. Check transmission operation - all ranges. Does not shift properly.
e. Note any loss of power or rough running
Loss of power or rough
f. Check driveline operation.