TM 5-2420-230-24-1
(4)
Select Mode 3 on loader mode selector (9).
(a)
Float position indicator lamp (6) should flash,
showing that Mode 3 has been selected.
(b)
Hold down return-to-dig button (7) and move
control lever (8) forward.
(c)
Release control lever (8).
(d)
When arms are at hood height, pull back on
control lever and release it.
(e)
Ensure arms stop lowering, and bucket has not
changed its position.
(f)
Move bucket to about 2 in. (5 cm) off ground.
(g)
Press on return-to-position control (10).
(h)
Arms will raise to about 24 in. (60 cm) off
ground and bucket will close to 18 in. (45 cm).
(i)
Raise arms above hood and open bucket halfway.
(j)
Press memory button (5).
(k)
Raise loader arms to maximum height.
(l)
Check antirollback device by trying to crowd bucket.
(m) Bucket should not come up against stop.
(n)
Press return-to-position button (10).
(o)
Arms and bucket return to position previously selected (just above hood).
(p)
Lower arms and place bucket flat on ground.
(q)
Raise loader arms as quickly as possible by pulling control lever (8) fully back.
(r)
Lower arms to ground.
(s)
Run engine at idle speed.
(t)
Raise loader arms by pulling control lever fully back. During this period, accelerate engine and observe
increase in speed of arms.
(u)
Open and close 4-in-1 bucket by using rotary switch (11).
(v)
Lower loader arms to ground with bucket level.
(w)
Disconnect 4-in-1 bucket hydraulic connections.
c. Follow-On Maintenance.
(1)
(2)
END OF TASK
Change 1
10-60