TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
OIL SEALING RING SLEEVE REMOVAL
NOTE: The following photos are not of the HR Converter
Housing but the sleeve removal procedure is identical.
Figure 215
Use a sleeve puller like the one shown.
Figure 212
Remove clutch front bearing locating ring.
Figure 216
Sleeve being removed.
See cleaning and inspection page.
NOTE: When installing a new sleeve it is recommended a press
or a driver be used to prevent damage to the sleeve and be sure
the notch in the sleeve is aligned with sleeve lock notch. Install
Figure 213
sleeve lock and capscrew. Tighten screw to specified torque
Remove oil sealing ring sleeve retainer screw.
Figure 217
Position new oil sealing ring on turbine shaft. Install turbine
Figure 214
shaft bearing on shaft with bearing outer locating ring down.
Remove screw and sleeve lock.
--37--