TM 5-2420-230-24-2
B3.9 and B5.9 Series Engines
Cold Start Timing Advance System (KSB) Pump Mounted (005-070)
Section 5 - Fuel System - Group 05
Page 5-105
The wiring harness used on the electric solenoid-style KSB
can be inspected using a multimeter.
NOTE: Pin B of the metro-pack connector is blank on the
electric solenoid-style KSB wiring harness.
The electric solenoid-style KSB wiring harness contains a
3-ohm resistor in the wire leading from port C of the metro-
pack connector to the KSB electrical solenoid connector.
The 3-ohm resistor is mounted to a bracket that is used as
a heat sink to absorb heat that is generated by the resistor.
port C of the metro-pack connector and the KSB electrical
solenoid connector.
Repair the wire if there is an open circuit.
(Spec = Less than 10 ohms).
port A of the metro-pack connector and the fuel pump
shutdown solenoid connector.
Repair the wire if there is an open circuit.
(Spec = Less than 10 ohms).
L-965