TM 5-2420-232-10
0004
SERVICE LIGHT REPOSITIONING
0004
Under normal circumstances the service lights are to be fitted to the cab "A" posts. However, when the machine is to be used
on the road, the service lights need to be repositioned to conform with the lighting regulations. In the on-road position the ser-
vice lights are located on top of the front bucket. Their alignment has been pre-set by the use of special locating dowels.
Position Service Lights for Road Travel
0004
1.
Release the securing clamp (Figure 96, Item 2).
2.
Lift the service light (Figure 96, Item 3) by the front edge and slide from support frame (Figure 96, Item 4).
3.
Disconnect the wiring harness behind the service lights (Figure 96, Item 3) by releasing the multi-plug connector (Figure
96, Item 1).
NOTE
Blackout drive light is attached to left-hand service light.
4.
Repeat for second service light.
435-A0307
Figure 96. Positioning Service Lights for Road Travel
04
Change 1