Table 3. After PMCS - Continued.
NOT FULLY MISSION
b. Check for large stones or build up of
debris on top of axle casings, between
axle case and chassis. Remove any large
stones carefully with pinch bar (Item 1,
a. Inspect backhoe controls, cables, and Will not function. Cable frayed.
b. Visually check for loose or missing
Any part missing. Class III leak.
bolts, fittings, hoses, and digging teeth.
Mounting point cracked or dam-
Check for broken or cracked shanks,
aged. Tighten teeth if loose.
cutting edges, and mounting points.
c. Visually inspect hydraulic lines,
Class III leak.
fittings, control valve, and cylinders for
leaks or damage.
d. Check backhoe boom, dipper,
Broken or cracked welds. Loose
stabilizers, main frame, and kingpost
or missing hardware.
assembly for cracks, broken welds, and
loose or missing hardware.
e. Verify all locking devices, safety pins, Locking devices or safety pins are
and latches are present and implements
missing or damaged, and latches
are securely locked in the travel position. are not locked.
Inspect tow pintle for damaged or missing Cracked, damaged, or missing
hardware and the mission
Rubber grommet missing or
Ensure the rubber grommet is in place and cracked.
in good condition.
a. Check for proper extraction and
Class III leaks. Damage to quick
retraction of hose assemblies.
disconnect coupling and mission
requires hose reel.
for leaks and damage.
Check air reservoirs for leaks, damage,
Air leaks or damage.
Exterior fluid leaks, missing items, or
Any brake fluid leak. Any fuel
damage to equipment.
leak or Class III oil or coolant
leak. Sheet metal torn or sharp