FUEL GAUGE RESISTOR
YES: Gauge has failed.
(220 OHMS) (R5) CHECK
NO: Resistor has failed.
NOTE: Check fuel gauge before checking resistor. Resistor is located on bottom of
monitor controller panel. Access resistor by removing bottom cover from monitor
FUEL LEVEL SENSOR
YES: Sender has failed.
NO: Check harness.
NOTE: Check fuel gauge before checking sender.
Disconnect harness from fuel level sender.
Observe fuel gauge.
Does gauge needle go to "E"?
Connect jumper wire between harness connector pins.
Does gauge needle go to "F"?