• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE AND PUMP CONTROLLER CIRCUIT DIAGNOSTIC PROCEDURES - CONTINUED
ENGINE AND PUMP CONTROLLER CIRCUIT DIAGNOSTIC PROCEDURES - CONTINUED

Maintenance Manual For Hydraulic Excavator Model 230Lcr
Page Navigation
  282    283    284    285    286  287  288    289    290    291    292  
img
TM 5-3805-280-24-1
Sub-System Diagnostics
PROPEL AUTO IDLE
YES: Wire are OK. Go to
RELAY (K10) HARNESS
next step.
CHECK
NO: Wire has failed.
Repair.
T118561 ­UN­21NOV98
Turn key switch OFF.
Remove harness connector from relay
With ohmmeter measure continuity from relay harness connector pin 5 to ground.
Is continuity measured?
Connect voltmeter from relay harness connector pin 1 to ground.
9015
15
Turn key switch to ON and measure voltage at pin 1.
90
Is 24 volts measured?
YES: Wire and isolation
diode V4 are OK. Go to
next step.
NO: Check wire for open.
If OK, go to diode V4
check.
T118362 ­UN­21NOV98
1--24-Volt Terminal
2--Ground Terminal
3--Relay Common
4--Relay Normally Closed
5--Relay Normally Open
Turn key switch OFF.
Disconnect wiring harness at propel pressure switch.
NOTE: Use "diode checking mode" on meter when checking this reading.
Connect an ohmmeter to relay harness connector pin 2 and pressure switch connector
pin 1.
Measure resistance, then reverse ohmmeter probes and measure resistance again.
Does resistance read approximately 500 ohms in one direction, and open in the other
direction?
­ ­ ­1/2
4-155


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.