Cylinder Head and Valves
ASSEMBLE ROCKER ARM ASSEMBLY
1. Lubricate shaft OD, rocker arm bores, and rocker arm
supports with clean engine oil.
IMPORTANT: The oil supply hole (B) on the rocker
arm shaft must be toward the flywheel
end of the engine.
2. Assemble springs, rocker arms, and rocker arm
supports onto shaft in the same location as removed
3. Install bowed washers and new end plugs (A) firmly in
B--Oil Supply Hole
end of shaft.
INSPECT, MEASURE, AND INSTALL FUEL
SUPPLY PUMP PUSH ROD--IF APPLICABLE
1. Remove and clean push rod (A). Label end(s) for
reassembly in same orientation.
Continued on next page