TM 5-3805-280-24-2
Lubrication System
20
4. Remove oil filter header (on left hand and remote
9
mount filters) or header/rear adapter (A).
5. Remove oil tube adapter (B) and remove tubes (D), if
equipped.
6. Clean all gasket material from mating surfaces. Inspect
all parts and replace if needed.
7. Install new gasket and O-rings (if required) and install
oil filter header (A). Tighten cap screws to
specifications.
Oil Filter Header Cap Screws--Specification
Torque ............................................................................. 35 Nm (26 lb-ft)
NOTE: For left hand and remote mount filters, use
general torque specifications for header retaining
cap screws.
8. Using a new gasket and O-rings, install adapter (B), if
equipped. Tighten cap screws to specifications.
Oil Tube Adapter/Oil Cooler Cover Cap Screws--Specification
Torque ............................................................................. 35 Nm (26 lb-ft)
A--Oil Filter Header/Rear Adapter
B--Oil Tube Adapter/Oil Cooler Cover
9. Connect turbocharger oil inlet line (C).
C--Turbocharger Oil Inlet Line
D--Tubes
10. On left hand and remote mount filters, connect oil
inlet and outlet lines.
IMPORTANT: Insure oil inlet and outlet lines are
properly clamped and protected to
prevent excessive motion or abrasion.
11. Spread a layer of clean engine oil on new filter
packing. Install filter and tighten until packing contacts
filter base. Tighten an additional 1/2--3/4 turn after
packing contacts base. DO NOT overtighten oil filter.
RG,20,DT7532 1917NOV973/3
13-302