Tooth Shank Preheat
Tooth Shank Fillet Weld
12.7 mm (0.5 in.)
25 ± 6 mm (0.98 ± 0.24 in.) from
edge of cutting edge
1138 kg (2500 lb) approximate
As close to but not less than 0.5 mm
REPLACE BUCKET TOOTH
CAUTION: Guard against injury from flying
pieces of metal; wear goggles or safety glasses.
IMPORTANT: Hold the drift at an angle towards the
bucket to avoid damaging the rubber
1. Use a hammer and drift to drive out locking pin. Hold
the drift at an angle toward the bucket.
NOTE: Alternate buckets may use different tooth
2. Remove tooth.
Continued on next page