TM 5-3805-280-24-2
Frames
REMOVE AND INSTALL BUSHINGS AND
SEALS
NOTE: Bushing can also be removed by welding three to
five weld beads on the inside of bushing. Bushing
will shrink enough to permit removal using a
hammer.
1. Remove and install bushings (C) and dust seals using
bushing, bearing, and seal driver set.
2. Install bushings with lubrication hole in alignment with
lubrication passage in pivot.
3. Install bushing to a depth equal to the thickness of dust
seal (H)
4. Install dust seals with lip towards the outside of
component.
A--Hydraulic Ram
B1--Pipe-Minimum ID to Clear Bushing OD
B2--Pipe-Maximum OD
B3--Pipe-Length of Bushing
33
C--Bushing
3340
D--Disks
17
E--Bushing Stop (Disk)
F--Pilot (Disk)
G--Ram Stop (Disk)
H--Thickness of Dust Seal
TX,33,UU3777
1925NOV961/1
21-39