Wiring Harness and Switches
IMPORTANT: If all wire strands are not crimped into
contact, cut off wire at contact and
repeat contact installation procedures.
NOTE: Readjust crimping tool for each crimping
8. Inspect contact to be certain all wires are in crimped
REPLACE WEATHER PACKTM CONNECTOR
IMPORTANT: Identify wire color locations with
connector terminal letters.
1. Open connector body.
2. Insert JDG364 Extraction Tool1 over terminal contact in
3. Hold extractor tool fully seated and pull wire from
NOTE: If terminal cannot be removed, insert wire or nail
through extractor tool handle and push terminal
contact from connector.
WEATHER PACK is a trademark of Packard Electric.
Included in JT07195A Electrical Repair Kit.
Continued on next page