TM 5-2420-230-24-2
Section 6 - Injectors - Group 06
Injector - Disassembly
B Series Shop Manual
Page 6-7
Injector - Disassembly
Clean the carbon residue from the nozzle. Use a brass
wire brush and a piece of hardwood dipped in test oil.
Remove the copper sealing washer and discard.
15 mm
Clamp the nozzle holder in a soft jawed vise and remove
the nozzle nut.
Remove the nozzle needle valve and intermediate plate.
NOTE: To avoid damage place injector nozzle and needle
valve in a suitable bath of clean test oil.
L-361