TM 5-3805-280-24-1
Tests
6. Disconnect pump control valve pilot lines at rear pump
regulator (A) and front pump regulator (B). Install plug
(C) in lines. Leave the fittings on regulator open. Lay a
shop towel over the fittings.
7. Run machine as specified.
Engine--Specification
Speed in Standard Mode ............................................................. Fast Idle
Work Mode--Specification
Position ........................................................................................ Dig Mode
E Mode Switch--Specification
Position .................................................................................................. Off
HP Mode Switch--Specification
Position .................................................................................................. Off
Auto-Idle Switch--Specification
Position .................................................................................................. Off
Propel Speed Switch--Specification
Position ....................................................................... Slow Speed (Turtle)
9025
A--Rear Pump Regulator
25
B--Front Pump Regulator
8. Raise the left track off ground for rear pump or the
99
C--Plugs
right track for front pump.
9. Actuate propel function to full speed. Record the cycle
time for one revolution.
Continued on next page
TX,9025,GG2655
1908JUN983/4
6-230