Camshaft Capscrew - Installation (1-22)
Section 1 - Cylinder Block - Group 1
B Series Shop Manual
Camshaft Capscrew - Installation
Be sure the gear is seated against camshaft shoulder.
Using a .001 inch feeler gauge, check to see if the feeler
gauge can be inserted between the gear and the shoulder
on the camshaft. If the feeler gauge can be inserted, the
gear is not properly seated.
Insert the camshaft capscrew into the gear retainer and
install the capscrew/retainer assembly into the camshaft.
Torque the camshaft capscrew to 27 Nm [20 ft-lb].
After torquing the camshaft capscrew to 27 Nm [20 ft-lb],
then rotate the capscrew an additional 180 of rotation.