TM 5-2420-230-24-2
Fuel Lines - Clean and Inspect
Section 6 - Injectors - Group 06
Page 6-16
B Series Shop Manual
Place the pump in a vise and torque the fittings to the
following values:
(A) Outlet Fitting
30 Nm
[22 ft-lb]
(B) Hand-Prime Fitting
30 Nm
[22 ft-lb]
(C) Inlet Fitting
30 Nm
[22 ft-lb]
Fuel Lines - Clean and Inspect
High Pressure Fuel Lines
Visually inspect the high pressure fuel lines for obvious
damage such as lines that have bent to facilitate injector
removal. High pressure pulses expand and contract the
injector lines which result in internal flaking at the bent
areas. Bent lines should be replaced.
Wash the fuel lines in clean solvent and blow dry with
compressed air. Make sure all paint chips are removed.
Visually inspect for cracks at both ends of the fuel lines.
L-370