TM 5-3805-280-24-2
Heating and Air Conditioning
10. Align clutch coil with roll pin (B) in head and install
coil. Install snap ring (A) with round edge facing
upward.
11. Connect clutch coil wire to ground screw on
A--Snap Ring
B--Roll Pin
TX,18,SB796
1921SEP984/6
12. Install pulley. Slight tap may be needed to properly
position pulley on shaft.
13. Install new snap ring (A) with rounded edge of snap
ring facing upward. Install removed shims (B) on front
head.
14. Align clutch head key way with key and install hub.
15. Tighten nut until clutch hub is tight against shims on
compressor shaft shoulder.
A--Snap Ring
B--Shims
18
1830
26
Continued on next page
TX,18,SB796
1921SEP985/6
18-46