REMOVE AND INSTALL BUCKET LINKS
A--Left Side Link
I--Washer (As Required)
B--Retainer Ring (2 used)
C--Pin (2 used)
E--Right Side Link
NOTE: Removal of bucket is not necessary for the
cylinder and arm to hold cylinder up when
removal of just the bucket links. Remove the
links-to-bucket cylinder pin (D) is removed.
bucket if the arm is also being removed. (See
Remove and Install Bucket in Group 3302.)
2. Remove the retainer rings (B) and pins (C).
As links-to-bucket cylinder pin (D) is removed, lower
1. Connect center link (H) to a hoist using a lifting
the left (A) and right (E) side links to the ground.
strap. Put a wooden block (G) between the bucket
Continued on next page