TM 5-3805-280-24-2
Hydraulic System
CAUTION: To avoid injury from escaping fluid
under pressure, stop engine, and relieve the
pressure in the system before disconnecting
hydraulic or other lines. Tighten all connections
before applying pressure.
5. Disconnect hydraulic lines (H).
6. Connect center link to a hoist using a lifting strap.
7. Put a wooden block between bucket cylinder and arm
to hold cylinder up when side and center
links-to-bucket cylinder pin (I) is removed.
8. Remove retainer ring (E) and pin (F).
9. As side and center links-to-bucket cylinder pin is
removed, lower links to the ground.
Take notice of washer (G) locations for assembly.
B--Bucket Cylinder
E--Retainer Ring
F--Pin
G--Washer (As Required)
H--Bucket Cylinder Rod End-to-Bucket Section
Top Port Line
33
--Bucket Cylinder Head End-to-Bucket Section
3360
Bottom Port Line
152
I--Side and Center Links-to-Bucket Cylinder Pin
J--Side Link
Continued on next page
TX,33,UU3812
1922SEP983/5
21-184