TM 5-3805-280-24-2
Hydraulic System
7. Install rod eye in sliding housing (B). Install housing in
the cylinder service stand.
B--Housing
TX,33,UU3813
1922SEP985/11
8. Remove the staked material from set screw (A) hole
using a small air grinder or a drill and bit.
9. Remove set screw (A). Remove the steel ball (B).
IMPORTANT: To avoid damaging the tapped hole for
set screw, the cap screw in the
JT30043-30 Hex Piston Nut Wrench
must be tightened against a side of the
nut without the tapped hole.
To avoid gouging side of nut, install a
piece of steel flat stock between nut
A--Set Screw
and cap screw.
B--Steel Ball
10. Install JT30043-30 Hex Piston Nut Wrench so cap
screw is tight against a side of nut (B) without the
tapped hole.
33
3360
160
Continued on next page
TX,33,UU3813
1922SEP986/11
21-192
