TM 5-3805-281-10
Operating the Machine
CONTROL LEVERS
CAUTION: Operators require single hearing
protection when operating vehicle with windows
or door open. Single hearing protection is
required by ground personnel within 23 feet of
the 330LCR vehicle at high idle.
Never place any part of body beyond window
frame. It could be crushed by the boom if boom
control lever is accidentally bumped or
otherwise engaged. If window is missing or
broken, replace immediately.
Prevent possible injury from unexpected
machine movement. Make sure you know the
location and function of each control before
operating.
Never place any part of the body beyond the window
frame. Replace missing or broken windows immediately.
The machine is factory equipped with the control pattern
shown.
IMPORTANT: Prevent possible machine damage.
When digging, avoid contacting tracks
with boom cylinders or bucket.
When digging over the end of the
tracks, propel motors should be at the
rear to minimize chain and sprocket
wear and to maximize machine stability
and lift capacity.
NOTE: With this control pattern, functions must
correspond to the black-on-white labels located on
the control console.
Do not contact tracks with boom cylinders or bucket.
A--Arm Out
When digging over the end of tracks, propel motors
B--Arm In
should be at the rear of machine.
C--Swing Left
D--Swing Right
When a lever is released, it will return to neutral. The
E--Boom Down
F--Boom Up
machine will remain positioned.
G--Bucket Load
H--Bucket Dump
TX,35,FF2005 1913AUG911/1
