TM 5-3805-281-24-1
Tests
Hydraulic Oil--Specification
Temperature ........................................................... 50 5C (120 10F)
5. Run the machine at specifications.
Engine--Specification
Speed ........................................................................................... Fast Idle
Work Mode Selector--Specification
Position ........................................................................................ Dig Mode
E Mode Switch--Specification
Position .................................................................................................. Off
HP Mode Switch--Specification
Position .................................................................................................. Off
Auto-Idle Switch--Specification
Position .................................................................................................. Off
Propel Speed Switch--Specification
Position ..................................................... Slow (Turtle) and Fast (Rabbit)
6. Lower the boom so bucket is approximately 300--500
9025
25
mm (12--20 in.) off the ground with the arm retracted
132
and the bucket curled.
7. Start propelling with the machine at the end of course
and the tracks aligned with the straight line. Actuate
the propel pilot controller to full stroke.
Continued on next page
CED,TX08227,3146
1929MAY982/3
6-279
