TM 5-3805-281-24-2
Hydraulic System
12. Remove nut (E) using the JDG911 Spanner Wrench.
33
13. Remove parts (B--D and F--H) using a puller.
3360
33
Bearings and spacers are a press fit.
14. Measure diameter of oil seal contact surface on drive
shaft.
Drive Shaft Oil Seal Contact Surface--Specification
OD ...................................................................... 60 mm (2.36 in.) nominal
OD .............................................................. 59.8 mm (2.35 in.) limit of use
A--Drive Shaft
B--Roller Bearing
C--Spacer
D--Spacer
E--Bearing Nut
F--Roller Bearing
G--Spacer
H--Roller Bearing
Continued on next page
CED,OUOE027,297
1903JUN9811/15
19-72