TM 5-3805-281-24-2
Hydraulic System
1--Swing Motor
14--Spring
31--Park Brake Release
51A--O-Ring and Backup
2--Brake Piston
16--Force Pin (12 used)
Valve and Cap Screw
Ring (2 used)
3--Valve Plate
17--Washer
32--Snap Ring (2 used)
51B--Backup Ring
4--Cover
18--47 x 61 x 3 mm
33--Snap Ring
55--Spring (2 used)
5--Plate
Bottom Washer
35--Make-Up Check Valve
64--Plug
6--50 x 61 x 3 mm Top
19--Friction Disk (2 used)
(2 used)
68--Plug (2 used)
Washer (3 used)
20--Valve Housing and
37--Snap Ring
69--Plug (2 used)
7--O-Ring
Cover
38--Snap Ring
70--O-Ring
8--Spring (24 used)
21--Separator Plate (3
40--Cap Screw (4 used)
71--O-Ring
43
9--Oil Seal
used)
42--Cap Screw (4 used)
72--O-Ring
4360
10--Output Shaft
23--Retainer
43--Roller Bearing
85--O-Ring
11
11--Piston (9 used)
24--Thrust Plate
44--Roller Bearing
87--O-Ring (2 used)
12--Cylinder Block
26--Packing (2 used)
51--Crossover Relief Valve
88--O-Ring (2 used)
13--Ball Bushing
30--Housing
(2 used)
CED,OUOE027,262
1920MAY982/8
1. Install snap ring (C) in groove next to oil seal surface
on output shaft.
2. Install the washer (A).
3. Install roller bearing (B) using a press.
4. Install the second washer and snap ring.
5. Install inner race of roller bearing (D) on output shaft
so the model number stamped on bearing is towards
the valve housing and cover.
6. Install snap ring (E).
A--Washer (2 used)
B--Roller Bearing
C--Snap Ring (2 used)
D--Roller Bearing
E--Snap Ring
Continued on next page
CED,OUOE027,262
1920MAY983/8
21-45
