TM 5-3805-281-24-2
Hydraulic System
CAUTION: Spring (H) is under pressure.
Remove spring load from snap ring before
removing it.
9. Push top washers (I) and spring (H) down using a disk
and a press. Remove snap ring (G).
43
10. Remove washers and spring. The 50 x 61 x 3 mm
4360
washers are next to the snap ring and the 47 x 61 x 3
8
mm washer is at the bottom.
G--Snap Ring
H--Spring
I--50 x 61 x 3 mm Top Washer (3 used)
--47 x 61 x 3 mm Bottom Washer
CED,OUOE027,261
1920MAY986/8
11. Remove snap ring (B) from output shaft (D).
12. Remove snap ring (C).
13. Remove cover (A).
14. Remove O-ring (E).
15. Push output shaft (D) from housing using a press.
A--Cover
B--Snap Ring
C--Snap Ring
D--Output Shaft
E--O-Ring
Continued on next page
CED,OUOE027,261
1920MAY987/8
21-42