TM 5-3805-294-23-1
0053
Table 1. DTC 636.05 - High-Pressure Fuel Pump Position Circuit Has High Resistance - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If between 2,500 - 3,500 ohms,
3.
High-Pressure Fuel
proceed to Malfunction 4.
Pump Position
3, WP 0369) between pins A
Sensor Faulty.
and B on high-pressure fuel
2.
If not between 2,500 - 3.500
pump position sensor. Note
ohms, proceed to Malfunction
reading. (Volume 5, WP 0800,
14.
Figure 83)
1.
Disconnect engine wiring
4.
ECU Connector J03
harness connector J03 from
Has Damage or
Loose Pins.
ECU. (Volume 5, WP 0800,
Figure 48)
2.
Visually inspect ECU
1.
If damaged or has loose pins,
connector J03 for damage and
replace ECU. (Volume 4,
loose pins.
WP 0508) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose pins, proceed to
Malfunction 5.
Visually inspect engine wiring
1.
If damaged or has loose
5.
Engine Wiring
harness connector J03 for
sockets, replace engine wiring
Harness Connector
damage and loose sockets.
harness. (Volume 4,
J03 Has Damage or
Loose Sockets.
(Volume 5, WP 0800, Figure
WP 0510) Restore machine to
48)
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 6.
Measure resistance (Volume
1.
If less than 10 ohms, proceed
6.
Open Circuit
to Malfunction 7.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
If greater than 10 ohms,
2.
Connector J03
socket G3 (Volume 5,
replace engine wiring
Socket G3 and
WP 0800, Figure 48) and
harness. (Volume 4,
Engine Wiring
engine wiring harness
WP 0510) Restore machine to
Harness Connector
connector X02 socket A.
original condition and perform
X02 Socket A.
(Volume 5, WP 0800, Figure
Harness Diagnostic Mode
83) Note reading.
Test. (Volume 3, WP 0345)
0053-3