TM 5-3805-294-23-1
0084
Table 1. DTC 654.13 - Injector #4 Calibration Fault - Continued.
Test or Inspection
Corrective Action
Malfunction
15.
After Calibration Complete
appears, select OK. (Volume
3, WP 0340)
16.
Select Exit and then select
Yes. (Volume 3, WP 0340)
17.
Select Reading and select
Disconnect From Model(s).
(Volume 3, WP 0340)
18.
Select Yes to terminate your
readings connection. (Volume
3, WP 0340)
19.
Turn key switch to OFF
position for a minimum of 90
seconds to complete the
calibration. (TM
5-3805-294-10). (Volume 5,
WP 0794)
20.
Clear and refresh DTCs. Note
1.
If DTC 654.13 is still an active
if DTC 654.13 is still an active
DTC, proceed to Malfunction
4.
DTC. (Volume 3, WP 0362)
2.
If DTC 654.13 is not an active
DTC, problem corrected.
1.
Replace ECU. (Volume 4,
4.
ECU Faulty.
WP 0508)
2.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794).
3.
Select Readings and select
Connect to Model(s). (Volume
3, WP 0340)
4.
Select Dearborn Protocol
Adapter (DPA 4+) USB for the
Readings Adapter, and select
OK. (Volume 3, WP 0340)
5.
Select Engine Control Unit
(ECU) Only. (Volume 3,
WP 0340)
0084-7