TM 5-2420-230-24-1
16.
Install the rubber boot over the sector shaft.
Pack grease under the lip of the boot before
installation (Figure 32).
Figure 32
17.
Install the dust cover on the frame side of the
sector shaft (Figure 33).
NOTE:
When installing the stick-on type cover, clean
the area with a suitable solvent and install
using an RTV material on the edge of the
cover.
Figure 33
18.
Install the pitman arm on the steering gear.
Refer to the "Pitman Arm Installation"
instructions in the "Common Procedures"
section of this manual.
19.
Fill the system with an approved fluid and
bleed the system if necessary.
K-40