TM 5-2420-230-24-2
Section 0 - Engine Disassembly and Assembly - Group 00 jection Pump - Removal (Rotary Type Pumps) (0-37)
In
B Series Shop Manual
Page 0-25
Locking the Pump (0-39)
Locate TDC for Cylinder Number 1 by slowly barring the
engine while pushing in on TDC pin.
BE SURE TO DISENGAGE THE PIN AFTER LOCATING
TDC.
14 mm
Loosen the CAV injection pump lockscrew, position the
special washer with the small opening showing, then
tighten the lockscrew against the pump drive shaft.
Torque Value: 7 Nm
[5 ft-lb]
3/8 inch
Loosen the lockscrew for the Stanadyne DB4 fuel injec-
tion pump. Position the special washer behind the lock
screen head. Tighten the lockscrew.
10 mm
The special washer on the Bosch injection pump must be
removed so the lockscrew can be tightened against the
drive shaft.
NOTE: Before removing the Bosch pump, the pump must be
locked with the No. 1 Cylinder in TDC position.
Torque Value: 30 Nm
[22 ft-lb].
Wire the special washer to the Bosch pump.
L-114