TM 5-2420-230-24-2
Section 0 - Engine Disassembly and Assembly - Group 00
Rocker Levers - Removal (0-29)
B Series Shop Manual
Page 0-21
Injector Puller 3823276
Remove the injectors. If the injector is extremely difficult
to remove, remove the injector o-ring and fill the bore
around the injector with a penetrating solvent. Attach the
injector puller and pull the injector out as far as possible,
then use the injector puller slide hammer to tap against
the puller nut and drive the injector into the bore. Re-
peating this procedure will allow the solvent to penetrate
to the injector tip and loosen the carbon deposits on the
tip.
Refer to Component Section 6 for the injector test
procedures.
Rocker Levers - Removal (0-29)
14 mm, Screwdriver
Loosen the nuts on the rocker lever adjusting screws and
loosen screws until they stop.
13 mm, 18 mm
Remove the pedestal/head bolts from the rocker shaft
pedestals and lift off the pedestal and rocker lever as-
semblies.
NOTE: Refer to Component Section 3 for disassembly of the
rocker lever assemblies.
Push Rods - Removal (0-30)
Remove the push rods.
NOTE: Refer to Component Section 4 for the push rod in-
spection procedure.
L-110
