TM 5-2420-230-24-2
B3.9 and B5.9 Series Engines
Crankshaft Wear Sleeve, Front (001-025)
Section 1 - Cylinder Block - Group 01
Page 1-59
Wear Sleeve Installation Tool, Part No. 3824078
Use the alignment tool to install the seal to the correct
depth in the housing. Use a hammer to drive the seal into
the housing until the alignment tool stops against the hous-
ing.
Hit the tool at 12-, 3-, 6-, and 9-o'clock positions to drive the
seal evenly and to prevent bending the seal carrier.
19 mm
Install the flywheel. Tighten the capscrews in sequence as
shown in the illustration.
Refer to Procedure 016-005.
Torque Value: 137 Nm
[101 ft-lb]
Install the clutch, transmission, and starter. Refer to OEM
service manual.
Operate the engine, and check for leaks.
Crankshaft Wear Sleeve, Front
(001-025)
Preparatory (001-025-000)
Remove the drive belt. Refer to Procedure 008-002.
L-737