TM 5-2420-230-24-2
Crankshaft Wear Sleeve, Front (001-025)
B3.9 and B5.9 Series Engines
Page 1-62
Section 1 - Cylinder Block - Group 01
Position the counterbore end of the driver onto the wear
sleeve.
Install two capscrews (without spacers or hairpin cotters)
through the driver and into the crankshaft capscrew holes.
Align the wear sleeve and driver perpendicular to the crank-
shaft.
Tighten the capscrews "finger-tight."
CAUTION
To prevent damage to the wear sleeve, do not exceed
one-half revolution of each capscrew.
Alternately tighten the capscrews one-half turn until the
sleeve is installed to a depth of approximately 16 mm [0.625
in].
Torque Value: 20 Nm
[15 ft-lb]
Remove the two capscrews.
Install the spacer on each capscrew.
Install the two capscrews.
L-740