TM 5-3805-280-24-1
Adjustments
ENGINE CONTROL MOTOR AND SENSOR
ADJUSTMENT
SPECIFICATIONS
Arm-to-Engine Control Motor
13 Nm (115 lb-in.)
Shaft Cap Screw Torque
When the following components are repaired or replaced,
or when engine speeds deviate from specification, the
engine control motor and sensor adjustment and engine
9010
learning control procedure must be performed.
20
9
Engine
Engine speed control cable
Engine control motor and sensor
Engine and pump controller
Fast and slow idle stop screws
NOTE: The engine control sensor is located inside the
engine control motor housing. Sensor is serviced
as an assembly with the engine control motor.
1. Check that fast and slow idle stop screws on the
injection pump are adjusted to specification. (See
Injection Pump Fast and Slow Idle Stops Adjustment in
this group.)
2. Turn key switch to ON.
TX,9010,UU3407 1919MAY981/3
3. Turn the engine rpm dial (A) to slow idle.
A--Engine RPM Dial
Continued on next page
TX,9010,UU3407 1919MAY982/3
3-48