TM 5-3805-280-24-1
Sub-System Diagnostics
1 TRAVEL ALARM CIRCUIT DIAGNOSTIC PROCEDURES
IMPORTANT: Do not disconnect electrical connectors while the engine is running. Damage to Engine and
Pump Controller or other components may result. Disconnect connectors only when instructed during a
test or check.
NOTE: Before troubleshooting the circuits, clean all terminals in the engine and pump controller and harness
connectors using a non-conductive lubricating contact cleaner, then try circuit operation again before proceeding.
TY16324 John Deere Contact Cleaner can be used.
1/1
TRAVEL ALARM 5 AMP
Remove fuse block cover.
YES: Fuse is OK. Go to
FUSE (F10) CHECK
next check.
9015
Remove fuse from fuse block.
15
NO: Replace Fuse. If
97
Using ohmmeter, check fuse for continuity.
fuse blows again, check
for short.
Is continuity measured?
1/1
4-162