TM 5-3805-280-24-1
Hydraulic System
IMPORTANT: Pistons must be installed into the same
bores because of wear pattern. Mark
pistons and respective rotor bores for
assembly.
02
2. Mark pistons and rotor (A) bores for assembly.
0260
12
3. Remove snap ring (B). Remove rotor (A).
4. Remove spring (C) and shaft (D).
5. Remove pin from center shaft (D) if replacement is
necessary.
A--Rotor
B--Snap Ring
C--Spring
D--Center Shaft
TX,02,UU3723
1918SEP984/11
IMPORTANT: Pistons must be installed into the same
seats in drive shaft because of wear
pattern. Mark pistons and respective
gear seats for assembly.
6. Mark pistons and drive shaft so pistons (A) can be
installed into the same seats at assembly. Remove
pistons.
A--Pistons
Continued on next page
TX,02,UU3723
1918SEP985/11
12-36
