TM 5-3805-280-24-2
Cylinder Block, Liners, Pistons and Rods
REMOVE CYLINDER LINERS
10
16
IMPORTANT: Cap screws and washers must be tight
to achieve an accurate liner height
reading.
1. Using D17526CI (or D17527CI) Dial Indicator and
JDG451 Gauge (or KJD10123 Gauge), measure height
(A) of each liner at 1, 5, 7, and 11 o'clock positions as
viewed from rear of engine. Record all measurements.
Cylinder Liner Height--Specification
Height above block................................ 0.030--0.100 mm (0.001--0.004
in.)
Maximum permissible difference................................ 0.05 mm (0.002 in.)
between readings within one
cylinder or between adjacent
cylinders
2. Remove cap screws and washers securing liners to
cylinder block.
IMPORTANT: DO NOT stamp top of piston. Piston
may be damaged.
3. Number cylinder liners and pistons. Stamp front of liner
A--Liner Height
to assure correct assembly. Do not stamp liner flange;
stamp on fire dam only.
Continued on next page
RG,10,DT7420 1912NOV971/3
13-129