TM 5-3805-280-24-2
Lubrication System
REMOVE AND INSTALL DIPSTICK TUBE
20
17
WITH OIL PAN INSTALLED
REMOVE DIPSTICK TUBE
1. Remove dipstick (A).
2. Using No. 33856 (5/16 in.) Collet, No. 28250 Actuator
Pin, and D01299AA Slide Hammer, remove dipstick
tube (B) from block.
INSTALL DIPSTICK TUBE
1. Coat end of new dipstick tube with LOCTITE 271
Thread Lock and Sealer.
NOTE: 6010--6910 Tractors use a straight dipstick tube.
2. Orient RH dipstick tube with first bend directed toward
rear of engine and centerline plane of first bend angled
20 degrees toward the crankshaft centerline.
Orient LH dipstick tube with first bend directed toward
rear of engine and centerline plane of first bend
parallel with the crankshaft centerline.
A--Dipstick
B--Dipstick Tube
LOCTITE is a registered trademark of the Loctite Corp.
RG,20,DT7527 1917NOV971/2
NOTE: JDG965 Dipstick Driver cannot be used for
straight dipsiick tube used on 6010--6910
Tractors. Use Engine Oil Dipstick Tube Driver
(dealer fabricated tool) on these tractors. Refer to
Group 199 Dealer Fabricated Tools.
3. Using JDG965 Dipstick Driver (C), install dipstick tube
until shoulder bottoms.
4. Install dipstick.
C--Dipstick Driver
RG,20,DT7527 1917NOV972/2
13-310