TM 5-3805-280-24-2
Buckets
REMOVE AND INSTALL TOOTH SHANK
IMPORTANT: Electrical current traveling from the
welder through the machine's electrical
system may damage the electrical
system, including the battery, and the
engine and pump controller. Before
welding on the machine, the battery
ground cable and wiring harness
connectors to the engine and pump
controller must be disconnected to
protect the machine's electrical system.
1. Disconnect the battery ground strap and the wiring
harness connectors to the engine and pump controller.
(See Welding on Machine in this group.)
TX,33,GG2396 1921SEP981/5
2. Being careful not to cut into cutting edge, remove weld
using a cutting torch or air arc equipment to remove
shank.
3. Grind all surfaces smooth.
33
3302
5
Continued on next page
TX,33,GG2396 1921SEP982/5
21-5
