TM 5-3805-280-24-2
Rock Drill
44
9506
1--Cylinder Attachment (2
7--Swivel Pin (2 used)
14--Screw (2 used)
21--Hoses Support
119
used)
8--Hose (2 used)
15--Bar
22--Screw
2--Screw (4 used)
9--Adapter (2 used)
16--Pin
23--Cover
3--Washer (4 used)
10--Cross-Tilting Cylinder
17--Articulator
24--Self-Lubricating Ring
4--Ring (2 used)
11--Grease Fitting
18--Screw (18 used)
(2 used)
5--Swivel Ring (4 used)
12--Screw (2 used)
19--Washer (18 used)
6--Ring (2 used)
13--Bar
20--Feed Cradle
14. Inspect, repair or replace parts as necessary.
1. Remove two screws (2) from one cylinder
attachment (1).
15. Install two self-lubricating rings (24), cover (23),
and screw (22).
2. Remove two washers (3), ring (4), two swivel rings
(5), ring (6), and swivel pin (7).
16. Install hoses and hoses support (21).
3. Repeat two previous steps for remaining cylinder
17. Install sides of feed cradle (20), eighteen screws
attachment (1).
(18), and washers (19).
4. Remove two hoses (8).
18. Install articulator (17).
5. Remover two adapters (9).
19. Raise pin (16) on a jack.
6. Remove cross-tilting cylinder (10).
20. Install bar (13), and two screws (12).
7. Remove grease fitting (11).
21. Support pin (16) with a jack and install bar (15),
and two screws (14).
8. Support articulator (17) with lifting device and
remove two screws (14), and bar (15).
22. Install grease fitting (11).
9. Support pin (16) with a jack and remove two screws
23. Install cross-tilting cylinder (10).
(12), and bar (13).
24. Install two adapters (9).
10. Lower pin (16) on the jack and remove articulator
(17).
25. Install two hoses (8).
11. Remove eighteen screws (18), washers (19), and
26. Install swivel pin (7), ring (6), two swivel rings (5),
sides of feed cradle (20).
ring (4), two washers (3), and two screws (2) for
each of two cylinder attachments (1).
12. Remove hoses on hoses support (21) and remove
the hoses support.
13. Remove screw (22), cover (23), and two
self-lubricating rings (24).
CED,OUOE019,17 1901APR992/2
23-110