TM 5-3805-281-24-1
System Information
A--Mating Harness
D--Pin Number of Harness
I--Harness Identification
Connector
Connector to Which
Number
Identification Number
Wire is Routed
B--Mating Harness
E--Wire Color
Connector
F--Pin Number of Harness
Identification Name
Connector
C--Routing Destination of
G--Front View of Harness
Wire (Shown as
Connector
Component
H--Name of Harness
Identification Number)
NOTE: The same names and identification numbers
(A) and a name (B). An end (front) view (G) of the
are used on all machine schematic and
connector is shown. Also, a diagram view of the
harness electrical drawings throughout the
connector shows connector pin number (F), wire color
Operation and Test Technical Manual so
(E) and destination of each wire (C and D).
components can easily be cross-referenced
from one drawing to another.
In the example shown, X20 Connector connects the
Monitor and Relay Harness to the Cab Harness. Pin 1
9015
(F) of the connector contains a Red/Grn wire (E),
The component location by harness drawing is a
05
25
which is routed to Pin 1 (D) of the connector for K4 (C)
pictorial representation that shows harness routing,
Drive Light Relay.
component location and mating harness connector
information.
NOTE: Pin numbers are location reference numbers
only--they are not printed on the connector.
The location of each component that is connected to
the harness is shown and identified by its
alpha-numeric identification number (J) and component
Each wiring harness component location is followed by
name (K). In the example shown, the component is
individual component connector drawings. These
also identified by an R number (L) that is actually
drawings show an end (front) view and a diagram view
marked on the part.
of each connector in the harness that connects to a
component.
Each connector that joins one harness to another is
identified by an "X" component identification number
TX,9015,MM2920B 1914DEC982/2
4-25
