TM 5-3805-281-24-1
Tests
6. To monitor pump delivery pressure, use the pressure
gauge on flow meter. As an alternative, use the laptop
computer with excavator diagnostics program (See the
installation procedure in this group.), the digital
pressure and temperature analyzer with transducers, or
gauges. For the analyzer or gauges install adapter (A)
and male quick couples to test port in pump housing,
7. Install the temperature probe on the hydraulic
tank-to-pump suction line. (See JT05800 Digital
Thermometer Installation in this group.)
8. Use the laptop computer with excavator diagnostics
program to monitor engine speed or install a
tachometer. (See JT05801 Clamp-On Electronic
Tachometer Installation in this group.)
9. Check that the flow meter loading valve is open.
10. Heat the hydraulic oil to the specified temperature by
closing flow meter loading valve to increase pressure
to approximately 20 685 kPa (207 bar) (3000 psi).
Hydraulic Oil--Specification
Temperature ........................................................... 50 5C (120 10F)
11. Operate the machine at specification.
9025
25
126
Engine--Specification
Speed ................................................................................. 2000 10 rpm
Work Mode Selector--Specification
Position ........................................................................................ Dig Mode
E Mode Switch--Specification
Position .................................................................................................. Off
HP Mode Switch--Specification
Position .................................................................................................. Off
Auto-Idle Switch--Specification
Position .................................................................................................. Off
Continued on next page
CED,TX08227,3144
1929MAY985/6
6-273