TM 5-3805-281-24-1
Adjustments
R134A COMPRESSOR OIL CHARGE CHECK
3. Flush the complete system with TY16134 air
Remove compressor if R134a leakage was detected
conditioning flushing solvent.
and repaired. See Remove and install Compressor in
Repair Manual.
4. If the compressor is serviceable, pour flushing
solvent in the manifold ports and internally wash out
Drain oil from the compressor and record the amount.
the old oil.
See Compressor Oil Removal procedure in this group.
NOTE: Drain oil and save if this is a new compressor.
5. Install a new receiver-dryer.
6. Install required amount of TY22025 refrigerant oil in
If the oil drained from a compressor removed from
the compressor. (See R134a Component Oil
operation is very black or the amount of oil is less than
Charge in this group.)
6 mL (0.2 fl oz), perform the following:
7. Connect all components, evacuate and charge the
1. Remove and discard the receiver-dryer.
system.
2. Remove, clean, but do not disassemble the
expansion valve.
TX,9031,UU3153 1913AUG961/1
R134A COMPRESSOR OIL REMOVAL
1. Remove compressor from machine. See Remove and
Install Compressor in Repair Manual.
9031
20
2. Remove inlet/outlet manifold from compressor, and
2
clutch dust cover.
3. Drain oil into graduated container while rotating
compressor shaft.
4. Record measured oil and discard oil properly.
5. Install new oil. See R134a Component Oil Charge in
this Group.
6. Install compressor. See Remove and Install
Compressor in Repair Manual.
TX,9031,UU3154 1913AUG961/1
