TM 5-3805-281-24-1
9. Install propel gearbox, motor and sprocket.
10. Install cap screws and washers (E). Tighten cap
screws (D).
Gearbox-to-Frame Cap Screw--Specification
Torque ......................................................................... 620 Nm (457 lb-ft)
11. Connect lines (B and D) and tighten fittings.
02
Propel Motor "BV" Port-to-Rotary Manifold Port "4" Line Fitting--
0250
Specification
8
A--Propel Motor Drain Port-to-Rotary Manifold
Torque ......................................................................... 205 Nm (150 lb-ft)
Bottom Tee Port Line
B--Propel Motor "BV" Port-to-Rotary Manifold
Propel Motor "AV" Port-to-Rotary Manifold Port "3" Line Fitting--
Port "4" Line
Specification
C--Propel Motor Speed Change Port-to-Rotary
Manifold "P1" Port Line
Torque ......................................................................... 205 Nm (150 lb-ft)
D--Propel Motor "AV" Port-to-Rotary Manifold
Port "3" Line
12. Connect line (A) and tighten fitting.
E--Cap Screw and Washer (20 used)
Propel Motor Drain Port-to-Rotary Manifold Bottom Tee Port Line
Fitting--Specification
Torque ............................................................................. 93 Nm (69 lb-ft)
13. Connect line (C) and tighten fitting.
Propel Motor Speed Change Port-to-Rotary Manifold "P1" Port Line
Fitting--Specification
Torque ............................................................................. 34 Nm (25 lb-ft)
14. Add gear oil. (See Swing Gearbox, Propel Gearbox
and Pump Gearbox Oil in Group 0004.)
15. Do Propel Motor Start-Up Procedure. (See procedure
in Group 0260.)
16. Install propel motor cover. Tighten cap screws.
Propel Motor Cover Cap Screw--Specification
Torque ............................................................................. 90 Nm (65 lb-ft)
17. Install track. Adjust track sag. (See procedure in
Group 0130.)
CED,OUOE023,147
1927MAY984/4
10-8
