TM 5-3805-281-24-2
Electrical System and Electrical Engine Controls
REMOVE AND INSTALL STARTING MOTOR
(OEM ENGINES)
NOTE: For test and repair of starting motor, refer to
Electrical system Repair chapter.
1. Disconnect battery ground (-) cable.
2. Disconnect all cables and wires from starter solenoid
(A).
3. Remove starting motor using JDG725 Starter Wrench.
Starting Motor
4. Install starting motor in reverse order.
5. Torque motor mounting hardware as follows:
Upper stud nut: 44 Nm (33 lb-ft).
Lower cap screws: 27 Nm (20 lb-ft).
RG,RG34710,1323
1923OCT971/1