TM 5-3805-294-23-1
0072
Table 1. DTC 652.06 - Injector #2 Circuit Has Low Resistance - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Measure resistance (Volume
1.
If any measurement was less
than 1 kohm, replace
3, WP 0369) between
electronic fuel injector
electronic fuel injector wiring
harness. (Volume 3,
harness connector C01 pin 2
and all other pins on electronic
WP 0409) Restore machine to
fuel injector wiring harness
original condition and perform
connector C01. (Volume 5,
Harness Diagnostic Mode
WP 0800, Figure 32) Note
Test. (Volume 3, WP 0345)
readings.
2.
If all measurements were
greater than 1 kohm, replace
#2 electronic fuel injector.
(Volume 3, WP 0408) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
1.
Disconnect engine wiring
6.
Engine Wiring
harness connector J01.
Harness Connector
J01 Has Damaged
(Volume 5, WP 0800, Figure
or Loose Sockets.
46)
2.
Visually inspect engine wiring
1.
If damaged or has loose
harness connector J01 for
sockets, replace engine wiring
damaged or loose sockets.
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 7.
Visually inspect ECU
1.
If damaged or has loose pins,
7.
ECU Connector J01
connector J01 (Volume 5,
replace ECU. (Volume 4,
Has Damaged or
Loose Pins.
WP 0800, Figure 46) for
WP 0508) Restore machine to
damaged or loose pins.
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose pins, proceed to
Malfunction 8.
0072-5