TM 5-3805-294-23-1
0095
Table 1. DTC 898.09 - Engine Speed Request Not Received or Timed Out - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Disconnect the following:
a. Connector X3. (Volume
5, WP 0800, Figure 84)
b. Connector X4. (Volume
5, WP 0800, Figure 85)
c. Connector X41.
(Volume 5, WP 0800,
Figure 102)
d. Connector X42.
(Volume 5, WP 0800,
Figure 103)
3.
Unmount and reposition the
cab wiring harness connectors
for service. (Volume 3,
WP 0312)
4.
Visually inspect connector X4
1.
If damaged or has loose
for damage or loose sockets/
sockets/pins, replace cab
pins.
wiring harness (Volume 4,
WP 0504) for socket side of
connector and machine wiring
harness (Volume 4,
WP 0516) for pin side of
connector. Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
2.
If not damaged or does not
have loose sockets/pins,
proceed to Malfunction 11.
Measure resistance (Volume
1.
If continuity is present,
11.
Open Circuit
proceed to Malfunction 12.
Between Connector
3, WP 0369) between
X30 Socket 4 and
connector X30 socket 4
2.
If continuity is not present,
Connector X4
(Volume 5, WP 0800, Figure
replace cab wiring harness.
Socket 29.
96) and connector X4 socket
(Volume 4, WP 0504) Restore
29. (Volume 5, WP 0800,
machine to original condition.
Figure 85) Note reading.
Clear and refresh DTCs.
(Volume 3, WP 0362)
1.
Remove engine compartment
12.
Connector H01 Has
lower access cover. (Volume
Damage or Loose
Sockets/Pins.
4, WP 0593)
2.
Disconnect connector H01.
(Volume 5, WP 0800, Figure
40)
0095-5