INSTALL SAE 3 FLYWHEEL HOUSING
On SAE 1 and SAE 2 and all aluminum flywheel
housings, the flywheel housing is installed AFTER the
CAUTION: Flywheel housing (A) is heavy. Plan
a handling procedure to avoid personal injuries.
1. On engines requiring a gasket between block and
flywheel housing, inspect cylinder block and flywheel
housing gasket surfaces to see that they are clean.
Scrape off all old gasket material. Install a new gasket
without sealant between block and flywheel housing.
2. Install flywheel housing on cylinder block.
NOTE: Use new cap screws when installing flywheel
Installing SAE 3 Flywheel Housing
3. Dip threads of cap screw in engine oil before installing.
Install and tighten cap screws to 407 N·m (300 lb-ft).