TM 5-2420-230-24-1
d. Installation.
Hydraulic cylinder is heavy. Use an
appropriate lifting device and follow safe
working procedures when lifting or moving
hydraulic cylinder. Failure to comply may
result in injury or death to personnel.
Ensure pins are lubricated before installing.
Failure to comply could result in damage to
equipment.
NOTE
Ensure all hoses and tubes are
reconnected to positions noted prior to
removal.
Install cable ties as necessary.
(1)
Attach suitable lifting device and sling to bucket cylinder (2).
Use care when removing or installing snap and retaining rings. Snap and retaining rings are under
spring tension and can act as projectiles when released and could cause severe eye injury.
(2)
Use lifting device to position bucket cylinder (2) and install with two pivot pins (5) and circlips (3) and
washers (4).
(3)
Connect two hydraulic hoses (1) to bucket cylinder (2).
e. Follow-On Maintenance.
(1)
Start engine and functionally test cylinder (TM 5-2420-230-10).
(2)
Check for leaks.
(3)
Fill reservoir as required.
(4)
Return backhoe in the stowed position (TM 5-2420-230-10).
(5)
Shut OFF engine (TM 5-2420-230-10).
(6)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
10-35