TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 53
CAUTION: Outer cone, double bearing cup, spacer and inner
bearing cone are replaced as a set.
Figure 55
Remove idler shaft assembly. NOTE: The 6 speed trans-
mission will have two gears and a heavier front bearing.
Figure 54
Remove low clutch inner bearing cone. NOTE: To remove the
inner cone bearing without damage; a special bearing puller
must be made (see diagram Fig. 54-A1 or the outer cage and
Figure 56
rollers may be pulled rom the bearing inner race and the inner
Remove 1st speed clutch drive gear retainer ring.
race can be removed after the low clutch assembly has been
removed from the transmission. See caution in Figure 53.
Figure 54-A
Figure 57
A timken bearing cup, No. 29520 must be used with the above
Remove drive gear.
bearing puller.
--10--
F-55
